BRP Can-Am Outlander 2015 Series Manual page 460

Subsection XX (FUEL TANK AND FUEL PUMP)
If readings are out of specification, refer to
LEVEL SENDER RESISTANCE TEST (AT FUEL
PUMP CONNECTOR)
.
If readings are as specified, refer to
SENDER INPUT VOLTAGE TEST
Fuel Level Sender Resistance Test
(at Fuel Pump Connector)
FUEL LEVEL SENDER RESISTANCE TEST
FUEL PUMP
FUEL LEVEL
CONNECTOR
Full
Pins 1 and 2
Empty
If resistance test at fuel pump connector is failed,
replace fuel pump module.
Fuel Level Sender Input Voltage Test
1. Set ignition switch to ON.
2. Disconnect fuel pump connector, refer to
PUMP CONNECTOR ACCESS
tion.
3. Measure for input voltage as follows.
REQUIRED TOOL
FLUKE 115 MULTIMETER
(P/N 529 035 868)
FUEL LEVEL SENDER INPUT VOLTAGE TEST
FUEL PUMP
BATTERY
CONNECTOR
Negative
Pin 1
terminal
TEST RESULT
Battery voltage is not
read
Wiring continuity is good
Wiring continuity is not
obtained
Fuel Level Sender Replacement
Replace fuel pump. Refer to
subsection.
18
FUEL
FUEL LEVEL
.
RESISTANCE
@ 20°C (68°F)
5 ± 1
100 ± 5
FUEL
in this subsec-
VOLTAGE
Battery voltage
SERVICE ACTION
Test wiring continuity
between fuel level
sender and multifunction
gauge
Replace multifunction
gauge
Repair or replace wiring
FUEL PUMP
in this
FUEL TANK VENT VALVES
Fuel Tank Vent Valve Test
Inlet Check Valve Test
1. Remove rear body module, refer to
section.
2. Remove multifunction gauge for access to
the vent system inlet hose, refer to the
LIGHTS/GAUGE/ACCESSORIES
3. Install a small hose pincher between the vent
pressure relief valve and the fuel pump vent in-
let.
REQUIRED TOOL
SMALL HOSE PINCHER
(P/N 295 000 076)
vmr2012-028-003_d
1. Pressure relief valve
2. Fuel pump vent inlet
3. Install small hose pincher here
4. Connect the vacuum/pressure pump to the fuel
tank vent hose inlet.
REQUIRED TOOL
VACUUM/PRESSURE PUMP
(P/N 529 021 800)
BODY
sub-
subsection.
vmr2013-028