BRP Can-Am Outlander 2015 Series Manual page 542

Subsection XX (FRONT DRIVE)
529036005
vmr2007-053-010_a
TYPICAL — CV JOINT SHOWN
1. Joint extractor tool
With an hammer, hit on the tool to separate joint
from shaft.
When joint and shaft are separated, remove boot
from drive shaft.
Remove and discard the circlip. A new one is in-
cluded in the boot kit.
Drive Shaft Boot Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Install the NEW circlip.
Pack bearing area with grease (included with the
new boot kit).
NOTE: Do not use or add other grease.
Install NEW drive shaft boot clamps.
FRONT DIFFERENTIAL
Front Differential Removal
1. Drain front differential. Refer to
MAINTENANCE PROCEDURES
2. Remove both front drive shafts. Refer to
FRONT DRIVE SHAFT
3. Detach vent hose from front differential.
6
PERIODIC
subsection.
in this subsection.
vmr2012-036-003_a
FROM LH SIDE
1. Vent hose
4. Remove bolts securing front differential to
frame.
vmr2012-036-004_a
1. Bolts securing front differential to frame
5. Remove the following Oetiker clamps from
front propeller shaft.
vmr2012-009-020_a
1. Oetiker clamps
6. Detach front propeller shaft from front differen-
tial by moving it rearward.
vmr2013-036