BRP Can-Am Outlander 2015 Series Manual page 674

Subsection XX (AIR CONTROLLED SUSPENSION (ACS))
ACS Module Installation
The installation procedure is the reverse of re-
moval procedure, however pay attention to the
following.
If a new ACS module is installed, check diodes
D7, D8, D9 to ensure that it is not defective as
it can damage the ACS module. The diodes D7,
D8, D9 are located on the main harness near the
ACS sub-harness junction. Refer to the appropri-
WIRING DIAGRAM
ate
Ensure that air hoses are properly inserted into fit-
tings, refer to the following illustrations.
vmo2010-011-102_a
TYPICAL - PUSH HOSE UNTIL THE MARK IS COMPLETELY
INSERTED
1. Fitting
2. Mark
A. Must be inserted into fitting
vmo2010-011-103
TYPICAL - HOSE PROPERLY INSERTED INTO FITTING
ACS COMPRESSOR RELAY (R5)
ACS Relay Continuity Test
1. Remove relay (R5) at the beginning of this sec-
tion.
2. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to .
868)
3. Measure resistance as per the following table.
TEST PROBES
Terminal 30
Terminal 87
4. Apply 12 volts on terminals 86 and 85.
5. Measure resistance again as per the following
table.
14
for diode location.
RESISTANCE
Open (OL)
TEST PROBES
Terminal 30
Terminal 87
If results are not as per the above tables, replace
relay.
ACS Relay Input Voltage Test
1. Remove relay (R5) at the beginning of this sec-
tion.
2. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
3. Place ignition switch to ON position.
4. Measure voltage as per the following tables.
TEST PROBES
Fuse box 6B (OG/GN)
Battery negative (-) post
TEST PROBES
Fuse box 5B (RD/BE)
Battery negative (-) post
If voltage is not as specified, check wiring, con-
nector and terminal condition.
ACS Relay Ground Wire Continuity
Test
1. Remove relay (R5), refer to
at the beginning of this section.
2. Disconnect module connector.
vmr2013-065-008_a
1. Module connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to .
868)
4. Measure resistance as per the following table.
RESISTANCE
Close to 0
VOLTAGE
Battery voltage
(± 12 Vdc)
VOLTAGE
Battery voltage
(± 12 Vdc)
FUSE AND RELAY
vmr2013-065