BRP Can-Am Outlander 2015 Series Manual page 679

Pressure Transducer Input Voltage Test
1. Remove seat and RH side panel.
2. Disconnect pressure transducer connector.
vmr2013-065-007_a
1. Pressure transducer connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
4. Place ignition switch to ON position.
5. Measure voltage as per the following table.
TEST PROBES
Pin 3 (PK/OR)
Battery negative (-) post
Refer to the following illustration for the pressure
transducer connector pinout.
vmr2010-004-108
Pressure Transducer Ground Test
1. Remove seat and RH side panel.
2. Disconnect pressure transducer connector.
vmr2013-065
Subsection XX (AIR CONTROLLED SUSPENSION (ACS))
VOLTAGE
Battery voltage
(± 12 Vdc)
vmr2013-065-007_a
1. Pressure transducer connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
4. Place ignition switch to ON position.
5. Measure voltage as per the following table.
TEST PROBES
Pin 1 (BK)
Battery positive (+) post
Refer to the following illustration for the pressure
transducer connector pinout.
vmr2010-004-108
Pressure Transducer Replacement
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Disconnect pressure transducer connector.
3. Remove Oetiker clamp.
4. Remove pressure transducer from hose.
VOLTAGE
Battery voltage
(± 12 Vdc)
RELEASING AIR
in this
19