BRP Can-Am Outlander 2015 Series Manual page 321

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (1000))
Tmr2011-016-006_a
1. Right housing of gearbox
2. Actuator
3. VSS (Vehicle Speed Sensor)
VSS Access
To reach the VSS, refer to
remove the following parts:
– Seat
– Console
– RH side panel
– RH engine panel (Renegade only).
VSS Wire Identification
COLOR -
FUNCTION PIN SENSOR
CONNECTOR
12-volt input
from fuse A
F5
Speed
signal
B WHITE
(to cluster
pin 9)
Ground
C BLACK
(to ECM C3)
VSS Circuit Protection
CONDITION
Supplied with main
relay activated
VSS Input Voltage Test
1. Remove VSS connector cover.
2. Set multimeter to Vdc.
4
BODY subsection and
COLOR -
WIRING
HARNESS
CONNECTOR
RED VIOLET/BLUE
PINK
GREEN/
BROWN
CIRCUIT PROTECTION
Fuse 5 of fuse block 1
(from main relay R2)
REQUIRED TOOL
FLUKE 115 MULTIMETER (P/N 529 035 868)
3. Turn ignition switch ON.
4. Set emergency engine stop switch to RUN.
5. Back-probe the VSS connector.
REQUIRED TOOL
FLUKE RIGID BACK-PROBE (P/N TP88)
vmr2012-020-020_a
1. VSS connector
6. Measure voltage as per following table.
VEHICLE SPEED SENSOR INPUT VOLTAGE TEST
TEST PROBES
PIN A PIN C
(VIOLET/BLUE
(GREEN/BROWN
wire) wire)
If voltage is not as specified, test positive and
ground circuits separately.
VSS Signal Test
1. Lift rear of vehicle so that rear wheels are off
the ground.
2. Set transmission to 2WD and to NEUTRAL.
3. Back-probe the VSS connector.
REQUIRED TOOL
FLUKE RIGID BACK-PROBE (P/N TP88)
4. Turn ignition switch ON.
5. Set emergency engine stop switch to RUN.
6. Set multimeter to Vdc.
RESULT
(KEY ON)
Battery voltage
vmr2012-020