BRP Can-Am Outlander 2015 Series Manual page 176

Subsection XX (MAGNETO SYSTEM)
Rotate starter double gear counterclockwise to
align intermediate gear teeth with sprag clutch
gear.
vmr2006-041-012_b
1. Starter double gear
2. Sprag clutch gear
3. Intermediate gear
ROTOR RETAINING SCREW
Service Product
Tightening Torque
SPRAG CLUTCH
Sprag Clutch Removal
Remove MAGNETO COVER
this subsection.
Heat screws in order to break the Loctite.
Loosen sprag clutch housing screws located in-
side rotor.
tmr2011-012-004_a
1. Rotor
2. Sprag clutch housing screws
ROTOR
Remove rotor (refer to
8
LOCTITE 648 (GREEN)
(P/N 413 711 400)
150 N•m ± 10 N•m
(111 lbf•ft ± 7 lbf•ft)
. See procedure in
in this subsection).
Remove sprag clutch gear.
Remove sprag clutch housing screws and sprag
clutch housing.
vmr2006-041-013_a
1. Sprag clutch housing screws
2. Rotor
3. Sprag clutch
4. Sprag clutch housing
Sprag Clutch Inspection
Inspect sprag clutch and sprag clutch housing for
wear and damage.
Also check the collar of the sprag clutch gear.
Rotate sprag clutch gear in sprag clutch.
NOTE: Sprag clutch must lock in counterclock-
wise direction.
vmr2006-041-014_a
SPRAG CLUTCH FUNCTIONAL TEST
1. Lock
NOTE: Sprag clutch, housing and gear must be
replaced at the same time, if damaged.
Sprag Clutch Installation
For installation, reverse the removal procedure.
However, pay attention to the following details.
vmr2013-014