Spindle Features Available For Spindle-Mode Servo - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
13 Spindle Control
13.6 Spindle-Mode Servo Motor Control

13.6.4 Spindle Features Available for Spindle-Mode Servo

The following spindle features can be applied to a spindle-mode servo motor in the same manner as normal spindle.
 Spindle rotation command (by S code)
 Forward run/reverse run command
 Encoder input I/F
 Spindle override
 Turret gear change
 Constant surface speed control
- Multiple spindle control
Multiple spindle control I (Command output destination is determined by spindle selection command)
Multiple spindle control II (Command output destination is determined by spindle selection signal)
- Spindle orientation
Orientation
Multi-point orientation
- Spindle position control (spindle/C axis control)
Zero point return type
Decelerate and stop type
- Spindle synchronization
Spindle synchronization I (G code method)
Spindle synchronization II (PLC signal method)
- Tool spindle synchronization I Polygon cut
Tool spindle synchronization IA (spindle-spindle polygon)
Tool spindle synchronization IB (spindle-spindle polygon)
Tool spindle synchronization IC (spindle-NC axis polygon)
 Tool spindle synchronization II (hobbing)
 Spindle speed clamp
 Feed per revolution
 Thread cutting
 Continuous thread cutting
 Variable lead thread cutting
 Circular thread cutting
 Thread cut override
 Variable feed thread cutting
 Synchronous tapping cycle
 Dwell (Revolution-based designation)
497 IB-1501668-B