Replacing The Plotter On The Stand - ENCAD CADJET 2 Service Manual

To avoid risk of personal injury or damage to the plotter, we
recommend that you have someone help you turn the plotter over
CAUTION
to place it in the shipping box.
9. Remove the eight screws which hold the plotter on the stand.
10. Stand close to the plotter. Place one hand around the plotter and
grasp the front of the Platen with the other hand. Lift the plotter
straight up approximately 4" to clear the legs.
11. Place the plotter upside down in the original shipping box with
foam support blocks in place.
3.2

Replacing the Plotter on the Stand

See the CADJET 2 User's Guide for the plotter assembly procedures if
you are using the desktop stand. If you are using the floor stand, have
someone help you position the plotter on the stand and hold it in place
while you insert and tighten the eight screws which hold the plotter on
the stand.
CADJET 2
Disassembly/Assembly
5-9