Table of Contents
Advertisement
Appendix B
PRINTER FIRMWARE UPGRADE
PROCEDURE
Note: 1. This procedure can be performed with a parallel cable or a
NOTE
1. Connect the Parallel Cable (or the RS422 Serial Cable) to the
computer and the plotter.
2. Insert the Utilities Disk provided with your plotter. You should use
the most current version of the firmware, which is CJDOS15.ZIP
(as of the date of publication of this manual). It is also available
on ENCAD's BBS. You may also contact our Help Desk to obtain
the most recent version if you do not have access to the BBS.
See Chapter 1, Section 3.0.
3. Power up the plotter. Wait until the Carriage has traveled across
the Platen and returned to the Service Station. Type B:\INSTALL
and press <Enter>.
(Or, type A:\INSTALL if your floppy drive is designated as "A.")
4. Answer "YES" or "NO" to "Do you want to print the
USERGUIDE.TXT now?" and press <Enter>.
5. Select the disk drive on which you want the DOS Utilities installed.
Press <Enter>.
6. Specify the destination subdirectory where the files are to be
installed. Press <Enter>.
CADJET 2
RS422 Serial Cable (parallel is faster). The RS422 Serial
Cable is available from ENCAD, Inc. The Part Number is
203977. See Chapter 7 of this manual. If you prefer to make
your own cable, see Figure A.1 at the end of Appendix A.
2. This procedure cannot be used if the Flash EPROM is blank
or corrupt). See Appendix A.
B-1
Advertisement
Table of Contents
