Table of Contents
Advertisement
6.0
Display Assembly
6.1
Removing the Display Assembly
1. Disconnect the power cord and the interface cables.
2. Using a #1 Phillips screwdriver, remove the 3 screws from the
back of the Keypad Top Assembly (and, if the Keypad Bottom is
damaged, the 2 screws from the underside of the front of the
Keypad Bottom and the three screws which hold the Keypad
Bottom to the Platen). See Figure Chapter 5 .13.
3. If the Right Cover Assembly has not been removed from the
plotter, you will need to lift up the left side of Keypad Top
Assembly and pull it slightly to the left in order to get the Keypad
Shim on the right end of the Keypad Top Assembly to clear the
overhang from the Right Cover Assembly.
4. Turn the Keypad Top Assembly over.
CADJET 2
Figure Chapter 5 .13: Display Assembly
Disassembly/Assembly
5-27
Advertisement
Table of Contents
