Table of Contents
Advertisement
Disassembly/Assembly
2. Push forward very firmly on the back of the Upper Roller Support
until the back of it clears the front of the Stabilizer Bracket and
snaps into place so that the entire Upper Roller Support is down
inside the Y-Bracket.
3. Grasping the roller between your fingers, move the Upper Roller
Support into place. Make sure the point on top back of the Upper
Roller Support is in its hole in the Y-Bracket. See Figure Chapter
5 .35.
Figure Chapter 5 .35: Positioning Upper Roller Supports
5-84
CADJET 2
Advertisement
Table of Contents
