Keypad Display Shows Load Media Message When Rollfeed Media Is Loaded - ENCAD CADJET 2 Service Manual

Troubleshooting
11.5.5
If the Keypad Display shows a LOAD MEDIA message, but you have
rollfeed media loaded, the plotter may not be configured for roll media.
From the Main Menu, press one of the arrow keys to advance to the
display shown below:
Press SELECT and press the DOWN ARROW three times. If the
following display appears,
the plotter is set for cut sheet media and needs to be changed for
rollfeed. To change the setup, press SELECT (the equals sign (=) will
blink) and one of the arrow keys so that the display reads as follows:
Press SELECT to save the change (the equals sign (=) will stop
blinking). Align the rollfeed media on the Platen and press the LOAD
button.
4-38
Keypad Display Shows LOAD MEDIA Message
When Rollfeed Media is Loaded
MAIN MENU
PRINTER SETUP
PRINTER SETUP
ROLL=OFF
PRINTER SETUP
ROLL=ON
CADJET 2