e.
flex cable into the connector at J3.
f.
2. To install the Encoder Sensor:
a. Turn the Carriage Assembly so that the bottom side of it is
facing up.
b. Push down on the plastic clip and slide the back of the
Encoder Sensor over it.
c.
Sensor snaps into place.
d. Turn the Carriage Assembly over and insert the Encoder flex
cable into the connector at J2.
e.
3. Perform the Carriage Assembly, Carriage Belt, and the Frame
Tensioner Reinstallation procedures to reinstall the Carriage
Assembly.
Replacing the Carriage Bushings
1. If there is not enough space on both sides of the Slide Shaft to
remove the Carriage bushings, perform the Carriage Assembly,
Carriage Belt, and the Frame Tensioner Removal procedures to
remove the Carriage Assembly from the Slide Shaft.
Turn the Carriage Assembly over and insert the Paper Sensor
Push both sides of the connector lock shut at the same time.
Push the Encoder Sensor in past the ridges until the Encoder
Push both sides of the connector lock shut at the same time.
NovaJet PRO 600e Service Manual
Assembly\Disassembly
5-33