ENCAD CADJET 2 Service Manual page 224

9. Secure the MPCB to the Right Side Plate using three screws. See
Section 4.3.2 and Figure Chapter 5 .29. Make sure the Trailing
Cable is not pinched between the stand-off and the MPCB.
10. Bring the Trailing Cable around the bottom of the MPCB and
connect it at the JP4 connector. Make sure the silver fingers
face down when the Trailing Cable is inserted into the
connector.
11. Route the Keypad Cable through the top left hole in the Right Side
Plate. Bring the Keypad Cable down around the flat edge of the
MPCB beneath the J1 connector. Connect the Keypad Cable at
the J1 connector on the MPCB. The silver fingers must face the
back side of the plotter when the Keypad Cable is inserted
into the connector.
12. Reconnect the Servo Motor wire (Red and Blue) to the J6
connector, the Stepper Motor wire to the JP5 connector, and the
Fan wire (Red and Black) to the J5 connector.
Figure Chapter 5 .6.
13. Reinstall the Trailing Cable Cover.
14. Reinstall the Right Cover Assembly. Make sure that none of the
harnesses or cables are pinched between the cover assembly and
the Right Side Plate. See Section 4.6.
15. Reinstall the Left Cover Assembly and the Filler Block.
Section 8.4, Steps 2-6.
16. Reinstall the Top Cover.
The entire plotter is now reassembled.
CADJET 2
Disassembly/Assembly
Reference
See
5-71