Observation Of Paper Skew At Rear Media Alignment Mark - ENCAD CADJET 2 Service Manual

8.4.2
To adjust
Rollers #8, #7, and #6
Rollers #5 and #4
Rollers #3, #2, and #1
1. Position a sheet of the appropriate size paper for loading. The cut
corner should be the top right corner of the paper as you load it.
Make sure the correct side is up against the rollers, and the right-
hand side is aligned with the Front Media Alignment Mark on the
front of the Platen.
Note:
NOTE
2. Hold the media and press LOAD. The paper will be pulled in past
the Platen's groove. The paper will roll forward (out) and stop.
CADJET 2
Observation of Paper Skew at Rear Media
Alignment Mark
Load
B-Size paper, with 11" side against rollers
D-Size paper, with 24" side against rollers
E-Size paper, with 36" side against rollers
Make sure that there is no gap between the right edge of the
paper and the left edge of the Front Media Alignment Mark
on the Platen.
Calibration
6-35