Introduction - ENCAD CADJET 2 Service Manual

Chapter 3
1.0

Introduction

This chapter contains general maintenance and cleaning instructions
for the CADJET 2 plotter.
information.
1.
WARNING
2.
CADJET 2
Always disconnect the power cord and the interface cables
before cleaning the plotter. An electrical shock hazard may
result if these procedures are not followed.
Never allow liquids to come in contact with the plotter's
electrical circuitry.
result in an electrical shock hazard and damage to the
plotter.
MAINTENANCE
Refer to Chapter 4 for troubleshooting
Failure to follow this procedure may
3-1