Table of Contents
Advertisement
4. Keep pressure on the front of the Upper Roller Support while
putting in the screws. Make sure the Upper Roller Support is
centered in its opening. Tighten the screws until snug (no more
than 3.0 In. Lbs. + 0.5 if using a torque screwdriver).
SURE YOU ARE TIGHTENING THE CORRECT SCREWS AND
NOT THE ONES WHICH HOLD ON THE STABILIZER
BRACKET!
Note:
NOTE
5. Repeat Steps 1 through 4 for the rest of the Upper Roller
Supports.
CADJET 2
To help center the Upper Roller Support, we suggest you:
1. Push the front of the Upper Roller Support towards the right
side of the opening as you put in the left screw and tighten it
a few turns.
2. Push the front of the Upper Roller Support towards the left
side of the opening as you put in the right screw and tighten it
a few turns.
3. Alternate between the two screws as you tighten them evenly
so that both sides become snug at about the same time.
Disassembly/Assembly
MAKE
5-85
Advertisement
Table of Contents
