Table of Contents
Advertisement
Disassembly/Assembly
To remove the Right Cover Assembly:
1. Remove the Top Cover. Keep the right end of the Top Cover tilted
up so that the Retracting Stop and Compression Spring don't fall
out.
2. You may find it helpful to wrap a rubberband around the connector
clips on the parallel port to hold them out of the way while the
Right Cover Assembly is being removed.
3. Move the Carriage Assembly to the middle of the Platen.
4. Using a #2 Phillips screwdriver, loosen the top and front screws
(which are captive) and remove the bottom back screw on the
inside of the Right Cover (see Figure Chapter 5 .5).
5. Remove the Right Cover. Move the Right Cover towards the back
of the unit as you remove it so that it clears the parallel port on the
back of the unit. Be very careful when removing the Right Cover
so that the LED's on the MPCB are not damaged.
5-12
CADJET 2
Advertisement
Table of Contents
