Table of Contents
Advertisement
8.1
Paper Skew Adjustment Sequence
It is very important that the sequence for the adjustment given in this
section be observed. Refer to Figure Chapter 6 .1 for the numbering
sequence of the Upper Roller Supports.
Note:
NOTE
1. Load a sheet of B-Size paper and adjust Rollers #8, #7, and #6,
following the directions in Section 8.4.
2. Load a sheet of D-Size paper and adjust Rollers #5 and #4,
following the directions in Section 8.4.
Note:
NOTE
3. Load a sheet of E-Size paper and adjust Rollers #3, #2, and #1,
following the directions in Section 8.4.
CADJET 2
The rollers should be adjusted moving from the right side
of the Platen to the left side of the Platen.
If you are not working with an E-Size unit, Step 3 below will
not be used.
Calibration
6-29
Advertisement
Table of Contents
