Table of Contents
Advertisement
Appendix B
7. Select the parts of the DOS Utilities you want to install by pressing
SPACEBAR to toggle between "YES" and "NO." Press <Enter>.
8. After the installation is completed, type CD CADUTIL (or CD and
the subdirectory specified in Step 6 above) and press <Enter>.
Note:
NOTE
9. Type CADUTIL and press <Enter>.
10. Type 1 and press <Enter>.
11. After a few seconds, the download will stop and the following
message will appear on your computer:
WARNING! THE NEXT PROCEDURE WILL ERASE THE CURRENT PRINTER
OPERATING SYSTEM. THIS PROCEDURE MUST NOT BE INTERRUPTED.
PLEASE INSURE THAT THE PRINTER IS NOT DISTURBED DURING THIS TIME.
12. Press <Enter> to continue with the download.
Note:
NOTE
13. After the Firmware has been upgraded, disconnect the power cord
and power up the plotter again.
14. When the process is completed, reset the plotter's User Settings
to the desired selections and start plotting again.
15. If you need assistance with the above procedures, please call
ENCAD's Help Desk at the number listed in Chapter 1,
Section 3.0 of this manual.
B-2
If you are already in the subdirectory where the files were
installed, this step is not necessary.
If at this point there is an error message reporting "PLOTTER
NOT ON LINE," the parallel download is not going to work.
In this case, you need to call ENCAD's Help Desk (see
Chapter 1, Section 3.0) and order ENCAD's RS422 Serial
Cable P/N 203977. (Be sure to tell the Help Desk that you
have received this error message.)
CADJET 2
Advertisement
Table of Contents
