Adjustment Of The Mounting Screws - ENCAD CADJET 2 Service Manual

Calibration
8.4.4
Figure Chapter 6 .12 shows how the motion (rapid drifting to the right
or to the left) of the roller determines which mounting screw should be
tightened in order to eliminate the motion of the roller so that the roller
stays in the center of the shaft and/or there is a gap when the Lower
Roller is rotated forward.
Note:
NOTE
Figure Chapter 6 .12: Motion of Rollers and Adjustment of Mounting Screws
Note:
NOTE
Once you have completed the adjustment of Rollers #8, #7, and #6,
adjust Rollers #5 and #4, beginning with Section 8.4.1. After Rollers
#5 and #4 are adjusted (if you have an E-Size model), adjust Rollers
#3, #2, and #1, beginning with Section 8.4.1.
Once all rollers are adjusted, proceed to Section 9.0.
6-38

Adjustment of the Mounting Screws

Pay attention to the orientation in Figure Chapter 6 .12.
After the mounting screw has been tightened to the maximum
torque setting available on the screwdriver, if the roller still
moves rapidly and touches, loosen the other mounting screw
to gain more adjustment range.
CADJET 2