Table of Contents
Advertisement
2. In media with a preprinted border, the optical sensor on the
Carriage Assembly may sense the preprinted border as the edge
of the media if the preprinted border is too wide. Use the Manual
Load function (see Chapter 2 in the CADJET 2 User's Guide for
instructions).
3. Certain media types may cause difficulty in loading.
Manual Load function (see Chapter 2 in the CADJET 2 User's
Guide for instructions).
4. The paper sensor may be defective. As an intermediate measure,
use the Manual Load function. See Chapter 2 in the CADJET 2
User's Guide for instructions. In order to test the paper sensor,
see Chapter 6, Section 6.5 for the Paper Sensor Potentiometer
Adjustment.
Assembly.
installation procedures.
CADJET 2
If it fails this adjustment, replace the Carriage
See Chapter 5, Section 8.0 for the removal and
Troubleshooting
Use the
4-35
Advertisement
Table of Contents
