Table of Contents
Advertisement
Troubleshooting
11.5.2
If the plotter feeds the media out of the plotter after the plot is
completed, there are three possible causes:
a. The media has been loaded incorrectly. The narrower edge of the
media must be placed under the rollers when the media is loaded.
The plotter determines media size by checking the narrow edge of
the media. Rotate the media and load again.
b. Non-standard media has been loaded. The plotter determines
media size by measuring the width and makes a determination of
the length based upon standard media sizes. Refer to Tables 1.1
or 1.2 in Chapter 1 for acceptable sizes.
Example:
c.
Paper Axis Calibration is out. Perform the Paper Axis Calibration
in Chapter 6, Section 10.2.
d. Image is too small for paper size selected in application. Set
SAVE MEDIA=ON on the plotter.
11.5.3
If the media skews or ripples as it moves through the plotter, there are
two possible causes:
a. The media was not loaded properly.
carefully load it again.
b. The Upper Roller Supports which hold the media have become
dirty, misaligned or excessively worn.
procedures in Chapter 6, Sections 7.0 and 8.0 and/or to the
removal and replacement procedures in Chapter 5, Section 14.0
of this manual.
4-36
Media Feeds Out of Plotter When Plot is
Completed
Set the plotter to MEDIA=ARCH if you use "C" size
Architectural media.
Media Skews or Ripples
Remove the media and
Refer to the alignment
CADJET 2
Advertisement
Table of Contents
