Table of Contents
Advertisement
4.5.2
For proper specifications and dimensions for the SIMM, please
refer to the CADJET 2 User's Guide, Appendix B. The SIMM must
WARNING
be within ENCAD's specifications and tolerances.
Note: 1. If you are installing two SIMMS, you must install the bottom
NOTE
1. The SIMM slots are at a 45° angle. Place the SIMM straight into
the connector as shown in Figure Chapter 5 .10.
2. Slowly push the SIMM down until the two side clips snap into
place. Make sure the SIMM is fully seated.
3. Go to Section 4.6 of this chapter for instructions on replacing the
Right Cover Assembly.
Figure Chapter 5 .10: Side View of SIMM Installation
CADJET 2
Extra Memory (SIMM) Installation
one first.
2. If you are installing two SIMMS, the SIMM in the top slot
MUST contain AS MUCH OR MORE capacity than the SIMM
in the bottom slot. For example:
16 MB in top slot, 4 MB in bottom slot, or
8 MB in top slot, 8 MB in bottom slot, or
32 MB in top slot, bottom slot empty.
Disassembly/Assembly
5-21
Advertisement
Table of Contents
