Upper Roller Supports - ENCAD CADJET 2 Service Manual

14.0 Upper Roller Supports

Note: 1. This procedure is to be used only if the Upper Roller
NOTE
CADJET 2
Supports become worn or damaged.
2. It is highly recommended that ALL the Upper Roller Supports
be replaced at the same time rather than just those that are
worn or damaged. This will ensure that all rollers have an
equal amount of use time and wear.
3. You will need the 4-1/2" x 1" x 1/32" piece of Oil Hardened
Precision Ground Flat Stock and also the piece of Translite
media in the list of recommended tools and fixtures in
Section 2.0.
4. If you need assistance during this procedure, call ENCAD's
Technical Support and Service department. See Chapter 1,
Section 3.0.
Disassembly/Assembly
5-77