ENCAD CADJET 2 Service Manual page 48

General Information
MODE COMMAND
MODIFY
MONOCHROME
NESTING
OPACITY
ORIENTATION
P1
P2
PAPER AXIS
PARALLEL INTERFACE An interface type in which a separate line is used for each
PARITY
PLATEN
PLOT AREA
PLOTTER
POROSITY
PRIME
1-22
This command sets the protocol parameters used to
initialize the Asynchronous
(Com Port).
The user may change a plotting parameter previously set by
the default values.
Printing done in only one color, usually black.
Placing two or more plots horizontally on the media.
The ability of media to prevent ink from showing through.
The direction of the plotted image on the media; that is,
portrait or landscape.
A scaling point used by the plotter that specifies the location
of the plot's lower left corner. On the CADJET 2, this point
will either be NORMAL or MAX.
A scaling point used by the plotter that specifies the location
of the plot's upper right corner. On the CADJET 2, this point
will either be NORMAL or MAX.
The long side of the plot area measured at right angles to
the platen; that is, the X-Axis or Vertical Axis.
data bit in a byte or word and all bits are transferred
simultaneously, making it faster than a serial interface.
A method for checking for errors in the transfer of
information between computing devices. Parity checks the
accuracy of the binary data on a serial connection.
The surface on which the media moves.
The area in which the plotter prints the image, determined
by the width of the media.
An electromechanical device that produces hardcopies of
computer data. Typically, this is done by moving the
drawing device and/or the media to create lines or filled
areas.
A measure of the flow of ink or air through the media.
To clear the ink cartridges by forcing them to fire rapidly.
Communications Adapter
CADJET 2