Mounting Screw Information - ENCAD CADJET 2 Service Manual

Calibration
8.2

Mounting Screw Information

Note:
NOTE
1. The torque requirements for the Upper Roller Support mounting
screws is 3 In.-Lbs. ± 0.5.
2. Turning the mounting screw clockwise will tighten the screw.
Turning the mounting screw counterclockwise will loosen the
screw.
3. Figure Chapter 6 .6 shows the Upper Roller Support and the
mounting screws. You must stand behind the plotter in order to
adjust the mounting screws on the Upper Roller Supports.
Figure Chapter 6 .6: Upper Roller Support and Mounting Screws
6-30
Read everything
Section 8.4. Make sure you understand this material before
you proceed to Section 8.4.
in Section 8.2 before beginning
CADJET 2