Table of Contents
Advertisement
7. If the Upper Roller Support does not come out easily, repeat
Step 5 again to put more of a bend in the Upper Roller Support
and then try to remove it. If the Upper Roller Support still does not
come out easily, you may find it necessary to use a pair of
Needlenose Pliers to bend up the bottom tab of the Upper Roller
Support.
damage the Slide Shaft or the Encoder Strip.
8. Working from the far left Upper Roller Support to the far right
Upper Roller Support, follow Steps 4 through 7 for each of the
remaining Upper Roller Supports. As you do so, be sure to keep
the Carriage Belt looped over the front of the Slide Shaft so it is
not damaged. ALSO, MAKE SURE YOU ARE LOOSENING THE
CORRECT SCREWS AND NOT THE ONES WHICH HOLD ON
THE STABILIZER BRACKET!
CADJET 2
Use extreme caution so that the pliers do not
Disassembly/Assembly
5-81
Advertisement
Table of Contents
