Plotter Hesitates During Plotting; Plot Appearance Is Not As Expected - ENCAD CADJET 2 Service Manual

Troubleshooting
Press SELECT. Try increasing the amount of memory allocated to the
I/O by pressing the arrow keys.
values in memory. Press MENU twice and the DOWN ARROW 4
times to return to the MAIN MENU, PRINT MODE.
Run the file again.
problem when transferring plots, additional memory must be added to
the plotter (refer to Appendix B of the CADJET 2 User's Guide), or
purchase ENCAD's Vector to Raster Conversion Utility.
solution may be to ask your software vendor for an HP-RTL device
driver. HP-RTL files don't require raster conversion by the plotter, so
memory is not an issue.

11.12 Plotter Hesitates During Plotting

Refer to the procedures in Section 11.11 in this chapter.

11.13 Plot Appearance is not as Expected

1. Keypad commands were not saved by pressing SELECT after
they were entered. Reset the parameters and be sure to press
SELECT after entering each parameter to save the commands.
2. Plotter emulation mode is not set correctly. Check to see that the
proper mode is entered and save by pressing SELECT.
3. Check to see that the proper driver is installed and selected.
4-56
Press SELECT to save the new
If this does not resolve the MEMORY FULL
Another
CADJET 2