Color Deadband Calibration - ENCAD CADJET 2 Service Manual

13.0 Color Deadband Calibration

Note:
NOTE
The purpose of the Color Deadband Calibration is to adjust the color
cartridge so that it prints the straightest lines possible.
1. Press MENU twice. The display will read:
2. Press the UP ARROW twice. The display will read:
3. Press SELECT and the DOWN ARROW. The display will read:
4. Press SELECT. The display will read:
The plotter will begin printing two rows of four vertical lines (black,
cyan, magenta, and yellow) 1/2" long across the paper one
segment at a time.
straighter than the color lines. The color segments should be as
close to being a straight line as you can detect. If the COLOR DB
is acceptable, record the value in Part 3 of the Calibration
Worksheet and proceed to Section 14.0. If it is not acceptable,
proceed to Section 13.1.
CADJET 2
If the plotting being done does not require any use of the
Tri-Color Cartridge, Section 13.0 can be skipped.
UTILITIES
CALIBRATION→
UTILITIES
MANUFACTURING→
MANUFACTURING
COLOR DB→
COLOR DB
YELLOW DB=X
The black lines will appear thinner and
X = CURRENT VALUE FOR
YELLOW DB
Calibration
6-57