Table of Contents
Advertisement
Calibration
Note: During these tests check the overall functioning of the plotter.
NOTE
6-42
Listen for:
1. any loud sounds from the Stepper Motor Assembly,
2. squeaking from the Roller Assemblies,
3. rubbing noises from the Drive Shaft,
4. or the Belt rubbing against the Pulleys or Stabilizer Bracket.
Also,
5. watch the tensioning mechanism for any adverse movement,
such as the tension being too tight on the belt or rubbing,
squeaking, or "chirping" noises.
6. check for Servo Motor noises or any visible Carriage
vibration.
Readjust the plotter if these sounds or conditions are present. If
the problem persists and cannot be corrected, call ENCAD's
Technical Support and Service department (see Chapter 1,
Section 3.0).
CADJET 2
Advertisement
Table of Contents
