Media Problems; Cut Sheet Media Won't Load - ENCAD CADJET 2 Service Manual

Troubleshooting
11.5

Media Problems

11.5.1
If cut sheet media won't load:
1. Check to see if the plotter is set for roll-feed media.
From the Main Menu, press one of the arrow keys to advance to
the display shown below:
Press SELECT and press the DOWN ARROW three times. If the
following display appears,
the plotter is set for roll-feed media and needs to be changed for
cut sheet. To change the setup, press SELECT (the equals sign
(=) will blink) and one of the arrow keys so that the display reads
as follows:
Press SELECT to save the change (the equals sign (=) will stop
blinking). Align a sheet of media on the Platen and press the
LOAD button. The media will be sized and pulled to the back of
the plotter until it reaches the starting position on the Platen.
4-34

Cut Sheet Media Won't Load

MAIN MENU
PRINTER SETUP
PRINTER SETUP
ROLL=ON
PRINTER SETUP
ROLL=OFF
CADJET 2