Table of Contents
Advertisement
10.1
Removing the Stabilizer Bracket
Refer to the appropriate sections of this chapter and to Figure Chapter
5 .23 while removing the parts listed below:
1. Remove the Cartridges and the Top Cover.
2. Remove the Left Cover Assembly and Left Side Plate.
Section 8.1.
3. Remove the Trailing Cable Cover, Frame Tensioner, Left Cam
Actuator, and Carriage Assembly. See Section 8.2.
4. Remove the Trailing Cable from the tapes on the Stabilizer
Bracket. See Figure Chapter 5 .23.
5. Use a 7/64 Hex Nut Driver to remove the three screws from the
back of the Y-Arm which hold the Stabilizer Bracket on the Y-Arm
and remove the Stabilizer Bracket. See Figure Chapter 5 .23.
CADJET 2
Disassembly/Assembly
See
5-53
Advertisement
Table of Contents
