ENCAD CADJET 2 Service Manual page 288

7. Press DOWN ARROW. The display will read:
8. Press DOWN ARROW. The display will read:
9. Press SELECT.
expects to be 21.00" +/- 0.05" long. The display will read:
10. Press FEED MEDIA and DOWN ARROW to unload the paper and
measure the line that was drawn. If the line is 21.00" +/- 0.05"
long, proceed to Section 10.2 below and perform the X-Axis
Calibration.
If the line is not 21.00" +/- 0.05" long, press SELECT, and then
press the UP ARROW or DOWN ARROW until the displayed
value matches the distance that you measured. Press SELECT to
save the new value. Reload the paper. The display will read:
Press MENU. Press SELECT. Another 21.00" line will be drawn.
Press FEED MEDIA and DOWN ARROW to unload the paper.
Verify that the line length is correct. Proceed to Section 10.2 and
calibrate the X-Axis.
CADJET 2
CALIBRATION
PAPER AXIS
CALIBRATION
CARRIAGE AXIS
The plotter will draw a horizontal line that it
CARRIAGE AXIS
WIDTH=21.00"
ROLL=OFF CUT=ON
SAVE MEDIA=ON
Calibration
6-45