ENCAD CADJET 2 Service Manual page 308

Calibration
Figure 6.1: Upper Roller Supports Numbering Sequence ........................................... 6-7
Figure 6.2: Inner Stand Off Screws and Turnbuckle ................................................. 6-10
Figure 6.3: Carriage Height Measurement Fixture .................................................... 6-14
Figure 6.4: Installation of Typical Black Cartridge ..................................................... 6-15
Figure 6.5: Top View of Carriage Board.................................................................... 6-23
Figure 6.6: Upper Roller Support and Mounting Screws ........................................... 6-30
Figure 6.7: Correct Positioning of the Spring in the Upper Roller Support ................ 6-32
Figure 6.8: Test for Minimum Acceptable Gap.......................................................... 6-33
Figure 6.9: Visual Verification of Gap between Roller and Y-Arm............................. 6-34
Figure 6.10: Paper Skew Acceptance Range for Rear Media Alignment Mark......... 6-36
Figure 6.11: Paper Skew Acceptance Range for Front Media Alignment Mark ........ 6-37
Figure 6.12: Motion of Rollers and Adjustment of Mounting Screws......................... 6-38
Figure 6.13: Deadband Alignment ............................................................................ 6-47
Figure 6.14: Vertical Lines (All) ................................................................................. 6-51
Figure 6.15: Vertical Lines (One) .............................................................................. 6-52
Figure 6.16: CADJET 2 Calibration Worksheet......................................................... 6-62
Table 6.1: Carriage Height Settings Chart ................................................................ 6-16
Table 6.2: Potentiometer Adjustment Flowchart ....................................................... 6-25
CADJET 2 6-65