Table of Contents
Advertisement
4. If the mounting screw on the right side is loosened (turned
counterclockwise), the roller will move to the left. If the mounting
screw on the left side is loosened (turned counterclockwise), the
roller will move to the right.
BOTH MOUNTING SCREWS AT THE SAME TIME ON THE
SAME UPPER ROLLER SUPPORT.
5. If you have loosened one of the mounting screws and the roller
has moved, and you need to move the roller in the opposite
direction, you must tighten that mounting screw BEFORE
loosening the other screw to move the roller in the opposite
direction. When tightening the first screw, turn it clockwise with
the torque screwdriver until the maximum torque is reached. Then
loosen the other screw. AGAIN, NEVER LOOSEN OR TIGHTEN
BOTH MOUNTING SCREWS AT THE SAME TIME ON THE
SAME UPPER ROLLER SUPPORT.
6. It is extremely important that you maintain downward pressure
(towards the floor) on the head of each screw at the same time as
you tighten or loosen the screws. Each screw must be completely
at the bottom edge of its hole in the back of the Y-Bracket. If this
is not done, the Upper Roller Support will not be perfectly
level and will not perform its function properly.
7. Following all of the information in Section 8.2 precisely will ensure
that the Upper Roller Support springs are deflected and the lower
tail of the springs will always be pressed against the Y-Arm's
vertical wall (without a gap) as shown in Figure Chapter 6 .7.
CADJET 2
NEVER LOOSEN OR TIGHTEN
Calibration
6-31
Advertisement
Table of Contents
