4.0
Right Cover Assembly, MPCB, and SIMMS
4.1
Removing the Right Cover Assembly
Removing the Right Cover Assembly provides access to the SIMMS,
MPCB, and all MPCB connectors (Stepper Motor, Servo Motor, Fan,
Keypad, and Trailing Cable).
There is a screw and nut in approximately the middle near the top
edge of the Right Side Plate. These have been set at the factory to
CAUTION
a specific torque. DO NOT tighten or loosen this screw and nut at
any time. See Figure Chapter 5 .25.
Note:
NOTE
Figure Chapter 5 .5: Inside View of Right Cover Assembly
CADJET 2
If the LED Keypad on the Right Cover Assembly needs to be
replaced, the entire Right Cover Assembly must be replaced.
Disassembly/Assembly
5-11