Table of Contents
Advertisement
Calibration
7. Press the UP ARROW until the display reads:
8. Load D-Size paper with the 36" side up against the rollers on the
Platen.
9. Press ACCESS CARTRIDGE. The Carriage will move out of the
Service Station.
10. Install a new Tri-Color Ink Cartridge and a new Black-104 JET
Cartridge, following the procedures for Cartridge installation in the
CADJET 2 User's Guide.
Do not ever wipe the ink Cartridges with any highly fibrous
materials like tissues or paper towels.
CAUTION
automatically wipes the ink Cartridges.
Note: 1. When installing the Black Cartridge, refer to Figure Chapter 6
NOTE
11. Press ACCESS CARTRIDGE.
return to the Service Station. Press MENU. The display will read:
6-40
MAIN MENU
PRINT MODE
.4.
Make sure that the Indexing Edge completely slides
under the Carriage Overhang. Hold the Cartridge down while
pressing forward, and keep pressure on the Cartridge while
turning the lever up to lock the Cartridge into place.
2. Do not push either Cartridge down AFTER the lever has
been turned up to lock the Cartridge into place. When the
lever is turned up, the Cartridge will automatically be put into
the desired position for the best contact with the Flex Cable.
MAIN MENU
PRINT MODE
The Service Station
The Carriage will automatically
CADJET 2
Advertisement
Table of Contents
