Slow Deadband Calibration - ENCAD CADJET 2 Service Manual

Calibration
11.1

Slow Deadband Calibration

The SLOW DEADBAND calibration shows the speed-dependent
Carriage height at 16 regions across the Platen with the values shown
in ZERO OR ONE. This value is displayed on both the menu and on
paper.
deadband.
1. Press MENU until the display reads:
2. Press SELECT. The display will read:
3. Press the UP ARROW once. The display will read:
4. Press SELECT & the DOWN ARROW twice. The display will
read:
5. Press SELECT. The display will read:
6-48
The plotter setup must be in the "NORMAL" mode to run
MAIN MENU
UTILITIES
UTILITIES
CALIBRATION→
UTILITIES
SERVICE→
SERVICE
CALIBRATION→
CALIBRATION
DEADBAND=XX *
* = DEFAULT NUMBER
CADJET 2