Table of Contents
Advertisement
FCC Statement (U.S.A)
The
(47 CFR 15.105 and 15.27) has specified that the following notice be
brought to the attention of the users of the CADJET 2.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
User Instructions:
If the equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of
the following measures:
l
l
l
l
Changes or modifications not expressly approved by ENCAD, Inc.
could void the user's authority to operate the equipment.
Note:
ii
United
States
Federal
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
This product was FCC certified under test conditions that
included the use of shielded I/O cables and connectors
between system components. To be in compliance with FCC
regulations, the user must use shielded cables and
connectors and install them properly.
Communications
Commission
CADJET 2
Advertisement
Table of Contents
