Table of Contents
Advertisement
Figure Chapter 5 .17: Trailing Cable Connector Lock on Carriage PCB
4. See Figure Chapter 5 .12. While you compress the back of the
Frame Tensioner with your left index finger, use your right hand or
the straight end of the Scriber to gently remove the Carriage Belt
from the Servo Motor pulley.
5. Remove the Compression Spring from the Frame Tensioner and
set it aside.
6. Push the Carriage Belt through the Frame Tensioner enough to
remove the Idler Pulley Assembly from the Frame Tensioner, and
then set aside the Idler Pulley Assembly and the Frame Tensioner.
(See Figure Chapter 5 .18 for part names, if necessary.)
7. Use a #1 Phillips screwdriver to remove the plastic Cam Actuator
from the left front side of the Y-Arm. See Figure Chapter 5 .18.
CADJET 2
Disassembly/Assembly
5-35
Advertisement
Table of Contents
