Running The Cartridge Diagnostic Test - ENCAD CADJET 2 Service Manual

Troubleshooting

11.10.1 Running the Cartridge Diagnostic Test

You will need to run the plotter's Cartridge Diagnostic Test to
determine which, if any, of the jets are not firing. To run the Cartridge
Diagnostic Test:
1. Turn on the plotter (you do not need to have it connected to your
computer in order to run this test). If power is already on, make
sure the following menu is displayed:
2. Press the DOWN ARROW once. The display will read:
3. Press SELECT once. The display will read:
4. Press the DOWN ARROW once.
a.
4-48
MAIN MENU
PRINT MODE
MAIN MENU
UTILITIES
UTILITIES
CALIBRATION→
If the display reads:
UTILITIES
OPTIONS=ADVANCED
press the UP ARROW twice. The display will read:
UTILITIES
SERVICE→
Go to Step 5.
CADJET 2