Table of Contents
Advertisement
Maintenance
Set the timer for 10-20 seconds, then remove. Dry the Cartridge
body (avoid touching the jet area). Reinstall Cartridge and run
PRIME again. Repeat steps as often as necessary to improve
PRIME. After a satisfactory PRIME plot is obtained, perform the
Cartridge Calibration. See Chapter 6, Section 12.0 of this service
manual.
4. If priming and the above maintenance procedures fail to unclog a
Cartridge, the Cartridge may be out of ink.
Note:
NOTE
3-10
Also see Chapter 4, Section 11.7 "Ink Cartridge Problems".
CADJET 2
Advertisement
Table of Contents
