Memory Full - ENCAD CADJET 2 Service Manual

11.11 Memory Full

If the MEMORY FULL error message displays while a plot is being
transmitted to the plotter, the I/O buffer has overflowed and the plot will
probably be incomplete. The plotter memory is allocated between the
HP-GL I/O and the Raster. The I/O buffer is for the transfer and
configuration of the incoming data. The Raster buffer is used for the
storage of the incoming plot.
The default configuration of the allocation is I/O = 128K and
Raster = 1M. If you are sending Raster files, increase the size of the
I/O buffer to decrease the transfer time, freeing up the computer
sooner. If you are sending vector files or merged vector/raster files,
increase the size of the Raster buffer to allow as much space as
possible to store and rasterize the complete file.
To reset the allocation, go to the following menu:
Press the UP ARROW 4 times to go to
Press SELECT. Press the UP ARROW twice to go to
Press SELECT to go to
CADJET 2
MEMORY FULL
PRESS ANY KEY
MAIN MENU
PRINT MODE
MAIN MENU
PRINTER SETUP
PRINTER SETUP
MEMORY CONFIG→
MEMORY CONFIG
I/0 = 128K RAS=1M
Troubleshooting
4-55