Table of Contents
Advertisement
Troubleshooting
2.0
Decision Logic Tables
2.1
Procedure for Using Decision Logic Tables
Note:
NOTE
The section of the DLT labeled "CONDITIONS" asks questions
concerning various conditions which can be answered "Yes" or "No" (Y
or N).
The section of the DLT labeled "ACTIONS" provides actions which can
be performed. The actions are listed progressively from simple to
complex, with the lowest cost/time factor first. The information is listed
in this order: Hardware, Software, Mechanical, and Electrical.
Use the following hypothetical condition to familiarize yourself with the
DLTs.
CONDITION
The media does not load. The plotter is a CADJET 2 and is receiving
power.
PROCEDURE
1. After reviewing all information at the top of Table Chapter 4 .1,
DLT 1, it has been determined that DLT 1 is the proper table to
use.
4-2
Always check the information at the top of the DLT carefully
so that you are aware of any warnings, references to other
manuals, any "Begin with" or "Exit to" information, and the
assumptions upon which the particular DLT is constructed.
After this information has been reviewed, locate the condition
with which you are dealing.
CADJET 2
Advertisement
Table of Contents
