Service Station Assembly; Removing The Service Station Assembly - ENCAD CADJET 2 Service Manual

7.0

Service Station Assembly

7.1

Removing the Service Station Assembly

Be sure to clean the Service Station Assembly BEFORE removing
it so that ink is not spilled. See Chapter 3, Section 4.0 for the
CAUTION
cleaning procedure.
Note:
NOTE
Figure Chapter 5 .15: Service Station Assembly
CADJET 2
The screw in the bottom of the Service Station Assembly
must be in place to attract the magnet on the underside of the
top of the Service Station Assembly.
Disassembly/Assembly
5-29