Plots Are Cut Off - ENCAD CADJET 2 Service Manual

11.14 Plots are Cut Off.

1. Check the setting of the MARGINS option in the PAGE FORMAT
menu. When MARGINS is set to NORMAL (the default), the plot
area is smaller than when MARGINS is set to EXPAND.
setting the MARGINS option to EXPAND to make the plot area
larger. See Chapter 1, Tables 1.1 and 1.2 of this Service Manual
for the Normal and Expanded plot areas for the different media
standards.
2. Check the defined plot area for the loaded media by selecting the
PLOT AREA option in the PAGE FORMAT menu. The plot area is
defined by the width of the loaded media, by the setting for the
MARGINS option, and by the selected MEDIA STANDARD in the
PAGE FORMAT menu (see explanation in the previous
paragraph).
3. If the plot area displayed by the PLOT AREA option is not large
enough for the image to be printed, try loading wider media. See
Chapter 1, Tables 1.1 and 1.2 of this Service Manual for the plot
areas for the different media standards.
4. The plotter may not have correctly sized the media.
MANUAL LOAD option to load the media. See "Manual media
loading" in Chapter 2 of the CADJET 2 User's Guide. You may
also want to refer to Section 11.5.4 in this chapter for further
assistance.
CADJET 2
Troubleshooting
Try
Use the
4-57