Table of Contents
Advertisement
Disassembly/Assembly
8.4
Reinstalling the Left Side Plate and Left Cover
Assembly
1. Align the Left Side Plate against the left end of the Platen, insert
the 4 screws, and tighten with a #2 8" Phillips screwdriver as tight
as possible.
2. Push the Left Cover Assembly all the way onto the Left Side Plate.
3. Insert the screw into the top back hole on the inside of the Left
Side Plate and tighten slightly. See Figure Chapter 5 .16.
4. Insert the second screw inside the block filler into the Left Side
Plate and tighten slightly. See Figure Chapter 5 .16.
5. Insert the third screw into the bottom back hole of the inside of the
Left Cover Assembly and tighten slightly. See Figure Chapter 5
.16.
6. Tighten the three screws with a #2 12" Phillips screwdriver.
7. Put the Top Cover back on.
8. Reinstall the Cartridges.
5-42
CADJET 2
Advertisement
Table of Contents
