Replacing The Carrier Bushings - ENCAD 60e Service Manual

f.
time.
2. To install the Encoder Sensor:
a. Turn the Carrier Assembly so that the bottom side of it is
facing up.
b. Push down on the plastic clip and slide the back of the
Encoder Sensor over it.
c. Push the Encoder Sensor in past the ridges until the
Encoder Sensor snaps into place.
d. Turn the Carrier Assembly over and insert the Encoder
flex cable into the connector at J2.
e. Push both sides of the connector lock shut at the same
time.
3. Perform the Carrier Assembly, Carrier Belt, and the Frame
Tensioner Reinstallation procedures to reinstall the Carrier
Assembly.

Replacing the Carrier Bushings

1. If there is not enough space on both sides of the Slide Shaft to
remove the Carrier bushings, perform the Carrier Assembly,
Carrier Belt, and the Frame Tensioner Removal procedures
to remove the Carrier Assembly from the Slide Shaft.
Push both sides of the connector lock shut at the same
Novajet PROe Series Service Manual
Assembly\Disassembly 127