Table of Contents
Advertisement
Disassembly/Assembly
6. After the Upper Roller Support is bent as much as possible,
replace the Flat Stock with the piece of Translite media to protect
the Lower Roller. Push the Upper Roller Support towards the
back of the unit and grasp the lower tab of it with the Needlenose
Pliers. Guide the lower tab of the Upper Roller Support up past
the front of the Stabilizer Bracket.
Make sure the Upper Roller Support does not catch on the front
edge of the Trailing Cable and that it does not damage the Slide
Shaft.
Figure Chapter 5 .33: Removing the Old Upper Roller Support
5-80
See Figure Chapter 5 .33.
CADJET 2
Advertisement
Table of Contents
